14”…16” Lathes

Box Rest – Standard Post 1" diameter

If you have a 14-16” lathe with 1” diameter post, such as the Robust Liberty, Robust Sweet 16, Robust Independence, Delta, General, Jet  or Rikon, these rests will probably fit.

The Box Rests are offset so that you can turn the rim and the inside all in one set up.  A removable pin is provided to keep you from going off the edge.  Sizes to fit most lathes.  The rest is 1.5” wide and overhangs 5”

Please contact me directly if your lathe meets any of the below criteria

NOTE: Older American Made Powermatic 3520 and 4224 lathes use 1 1/8” posts.

EXCEPTIONS:  Some imports, notably the Grizzly 0766 and G0800 have very short banjos.  You will need to special order extra-long post toolrests to fit these lathes.  Please see “Toolrest Dimensions” to see if our rests will work. If you need extra-long posts, please see “Metrics and Specials”.

25MM POST WARNING: Certain Grizzly, Laguna and other imported lathes may use 25mm posts which are slightly smaller than 1”.  THESE WILL NOT WORK. PLEASE MEASURE YOUR POSTS BEFORE ORDERING. FYI: 25mm = .984”, and 1” = 25.4mm. 25mm posts are available special order.